On Wed, Oct 13, 2010 at 6:39 PM, Erick Njenga <eriknjenga@gmail.com> wrote:
I have two hard disks that I want to configure to work in a Master-Slave arrangement. any ideas? any software I need to know about?
LOL. Well, for PATA/IDE disks, you just use the little jumpers. There is a label/guide on the disk on where to place the jumper to make the disk master or slave. For SATA, you decide with port to place the disk on, i.e SATA0, SATA1, etc. For SCASI, it's a little bit more complicated but I believe you are not handling SCSI, because that would be a mistake!:-) -- Best regards, Odhiambo WASHINGTON, Nairobi,KE +254733744121/+254722743223 _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ "If you have nothing good to say about someone, just shut up!." -- Lucky Dube