Hi Washington, Hope you got a solution if not here is one to try. The challenge is that Cisco flashcards are formated in FAT16. This is what you do: - Boot your router with the working flashcard. - Once done, and can access the normal global config mode, remove the working flashcard. - Insert the new flashcard, and issue the format flash command - Your card is now ready, and you may copy relevant files. Regards, Stan Ngure On Wed, Jul 14, 2010 at 7:22 PM, Odhiambo Washington <odhiambo@gmail.com>wrote:
I was playing around (seriously) with the flash mem (is it called thus?) upgrade procedure on a Cisco 2811. Needed to learn how it is done. So I wanted to install a 128MB flash (not from Cisco) to replace the 64MB from Cisco.
After go-ogle failing to show me the correct page, I resorted to a copy to tftp and back. I saw an option of copying to a flash disk (usbflash) but it couldn't read the 8GB one that I have (obviosuly due to the system limitations, iirc).
Now just to get to know how others do it, what is the correct procedure?
-- Best regards, Odhiambo WASHINGTON, Nairobi,KE +254733744121/+254722743223 _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ "If you have nothing good to say about someone, just shut up!." -- Lucky Dube
_______________________________________________ Skunkworks mailing list Skunkworks@lists.my.co.ke http://lists.my.co.ke/cgi-bin/mailman/listinfo/skunkworks ------------ Skunkworks Server donations spreadsheet
http://spreadsheets.google.com/ccc?key=0AopdHkqSqKL-dHlQVTMxU1VBdU1BSWJxdy1f... ------------ Skunkworks Rules http://my.co.ke/phpbb/viewtopic.php?f=24&t=94 ------------ Other services @ http://my.co.ke